Hello Guest it is March 28, 2024, 02:38:51 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - mmill

Pages: 1
1
General Mach Discussion / Problem after calibration
« on: September 16, 2012, 08:16:11 PM »
Hi!
After calibration of my 6040 cnc, everything looks ok. Even if i do the calibration again, so I know my calibration is saved. But when I run a program they moving almost 1-4mm too tar, depending on the distance. I use recommended data for velocity(2000) and acceleration(200) step pulse( 10 )dir pulse (5) steps per(320 before calibrated). Anyone know how to solve my problem? Thanks!

Pages: 1