1
General Mach Discussion / Re: Problem after calibration
« on: September 21, 2012, 04:06:36 AM »
I tried the latest mach version. Same problem. The calibration works well and is so accurate as I want and when tell mach3 to move 100 mm it moves 100+-0,03. But when I run a program for a detail 100x100mm it is around 104 x 97. I tried to adjust the steps per unit out of this value with access. But after an hour I needed to change it again.... It is possible that the problem is in my control box? Maybe I should buy a gecko g540?