Guest
Show Posts
1
General Mach Discussion / Tool shows up as an error!
« on: September 28, 2012, 10:08:16 AM »
Morning All!
Just finished building my table, 5x10 CandCNC, and Sheetcam. I'm pretty close to getting good cuts. But when I load a tap file from sheetcam the tool always shows up in the error dialog. I entered all the info from the charts from Hypertherm for 45A finecut consumables Also sometimes during a cut an error will flash intermittantly about tip voltage, but it flashes by too fast for me to see exactly what tge message is. Any help would be aopreciated..... It's great to see the machine workung, just need to do a little more tuning!
Oldsarge
Just finished building my table, 5x10 CandCNC, and Sheetcam. I'm pretty close to getting good cuts. But when I load a tap file from sheetcam the tool always shows up in the error dialog. I entered all the info from the charts from Hypertherm for 45A finecut consumables Also sometimes during a cut an error will flash intermittantly about tip voltage, but it flashes by too fast for me to see exactly what tge message is. Any help would be aopreciated..... It's great to see the machine workung, just need to do a little more tuning!
Oldsarge