Messages

61

General Mach Discussion / Re: smoothstepper help

« on: February 07, 2013, 02:13:34 PM »

will probably be about 8 if thats ok, ill pm you

bugger spindle isnt working either, it starts and stalls instantly

62

General Mach Discussion / Re: smoothstepper help

« on: February 07, 2013, 01:49:32 PM »

lol, ill be out in the garage after dinner.

google teamviewer, you dont need to install it just run it.
ill give you my ID and password and bosh your in, full control

63

General Mach Discussion / Re: smoothstepper help

« on: February 07, 2013, 01:44:11 PM »

ummm things still arent working?

XYZ is working perfect.

hood you dont want to remote in and take a look do you?

64

General Mach Discussion / Re: smoothstepper help

« on: February 07, 2013, 01:24:31 PM »

so am i going to need to tweak the wiring for the atc?

65

General Mach Discussion / Re: smoothstepper help

« on: February 07, 2013, 10:08:15 AM »

ops its cos i didnt have the db25 plugged in.

now my atc which is connected via port 2 on the smoothstepper uses pins 2, 3, 4, 5, 14 and 16

66

General Mach Discussion / Re: smoothstepper help

« on: February 07, 2013, 09:23:53 AM »

why am i struggling to much?!

i setup a new profile for the smoothstepper but all i get the reset flashing it wont let me click it?

ahhh this is turning into a nightmare

67

General Mach Discussion / Re: smoothstepper help

« on: February 07, 2013, 07:18:39 AM »

sorry to pester but can anyone help i really need to get my cnc up and running

68

General Mach Discussion / Re: smoothstepper help

« on: February 07, 2013, 04:50:58 AM »

http://www.soigeneris.com/Document/Warp9/SmoothStepperUserManualV1.0.pdf

page 5 - its very unclear which what i need to do to change port 2 to an output?

69

General Mach Discussion / Re: smoothstepper help

« on: February 07, 2013, 03:48:17 AM »

ah must have missed that will take a look many thanks

70

General Mach Discussion / smoothstepper help

« on: February 06, 2013, 07:09:22 PM »

ok so i just got an ethernet smoothstepper, port 1 is working fine. XYZ all home and hit the limit switches.

but cant get port 2 working for the ATC, nothing is happening.

anyone offer any advice?