Hello Guest it is March 28, 2024, 08:00:58 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - DavePr

Pages: 1
1
I need some help from the experts. I have a home built machine that I purchased. It is about 5' x 12'. I have the bed set up to cut out 49" x 97". I want to set my home position in the lower right corner if you were looking at the machine from the front. I know that I can move the machine to that point and either zero all the DRO's and it will return there each time I push the move to zero buttton. Until, I turn the computer off. Then it goes to another spot. I have tried putting the machine in the spot I want and then clicking the Ref All button, but it doesn't seem to work. Also, the guy I bought it from and a very small section of the overall table set up in the soft limits. I have scoured the forums on here and CNCzone to see if I could find the answer, but it seems like all the ideas are discussed around having switches hooked up. Some days I'm sure I will get to that point, but it wont be for a while. So if anyone can help me, I would sure appreciate it.

Thanks
Dave

Pages: 1