Messages

1

General Mach Discussion / Re: Mach 2 Screen Questions

« on: April 12, 2007, 09:47:54 AM »

Hey Brian, thanks for the reply!

I will check to see if that output1 is as you say it is, spindle-related. Also, the code does have a S10000 in there like you said! I just don't understand why it all of a sudden started to show up... (maybe I just wasn't paying that close of attention, which is pretty possible.  )

2

General Mach Discussion / Mach 2 Screen Questions

« on: April 11, 2007, 12:55:37 PM »

I'm trying to slowly understand this program. So far it works alright, but what exactly does the following "circled" items do?

Output1 is red; is this normal? It seems that anytime I have problems, this is red... then again, it may always be on, (not sure?)


And when I set the spindle to 100 is bumps up to 10000 after running through the drilling process... why would the spindle change in speed?

Any ideas would be great.