Hello Guest it is November 28, 2023, 05:14:14 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - ChuckNNashville

Pages: 1
General Mach Discussion / MPG Mode and jog buttons problem
« on: August 14, 2012, 03:13:46 PM »
Is there anyway to move the MPG Mode and job buttonsfrom the right side of the screen to the left or even in a seperate window?


*****VIDEOS***** / Z-axis problem on our drill
« on: August 08, 2012, 04:58:09 PM »

We are having an issue with our drill.  It will run the .mmg file just fine, but over time the Z-axis on the drill starts to go higher and higher which causes the drill-bit to eventually not even touch the slab of wax in which we are trying to drill into.  Any ideas on how to fix it?

I use ArtCam JewelSmith 2008, with a 3 axis mill.  I save all my toolpaths to an .mmg file.  Once I switched to Mach3 with a new 4 axis mill, my Z is going crazy.  My CAD software will save my work to about a hundred different G-code files so what is the best one to use with Mach3?  My mill is a Taig with Gecko stepper motors.  any help is appreciated.  Chuck

Pages: 1