Hello Guest it is March 28, 2024, 03:37:10 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - BOATDUDEGUY

Pages: « 1 2 3 4 5
41
General Mach Discussion / NEW WITH MACH, HAVING ISSUES
« on: July 28, 2012, 01:12:18 PM »
have a new 3020 cnc
small cheap chinese machine
and running into an issue with my x axis will shift on the second pass of a contour
does anyone know where im going wrong or something i should try
im very good with mastercam witch is what im programming with, same programs ran on other machines never failed
im just new with this diy hobby stuff and im certain theres somthing im doing wrong with mach, seing how ive only been using it a week
got the motors tuned
the image is of a contour cut, no roughing then finishing and that shot is of the second pass, ive tried cutting acceleration of motors in half
ive done .1 depths of cut to .025 per pass

any and all help is greatly apprecitated

Pages: « 1 2 3 4 5