1
General Mach Discussion / SAVING WORK LOCATION
« on: February 20, 2014, 12:32:05 PM »
once i set my work in the middle of my vice or chuck, can i save that location
because the last time i used it i had to find the x and y each time i turned on mach, is there a way other than just once i find it move away say in x4. and y4. and just remeber and move that much once i turn it back on
same for tool zs
is there a way or must i find my work and tool zero each time i boot up mach
thanks in advance
because the last time i used it i had to find the x and y each time i turned on mach, is there a way other than just once i find it move away say in x4. and y4. and just remeber and move that much once i turn it back on
same for tool zs
is there a way or must i find my work and tool zero each time i boot up mach
thanks in advance