Messages

51

General Mach Discussion / Re: z steper trouble

« on: December 18, 2012, 11:37:40 PM »

Yes

52

General Mach Discussion / Re: z steper trouble

« on: December 18, 2012, 07:47:25 PM »

tried G0 Z200.00 , , Still get close to the same, , it was 0.4 MV running and 0.4 stopped

53

General Mach Discussion / Re: z steper trouble

« on: December 18, 2012, 06:47:42 PM »

I coded g01 z3.000 f05 and measured it for some time, , I didnt measure it stopped. I can though

54

General Mach Discussion / Re: z steper trouble

« on: December 18, 2012, 06:33:01 PM »

Yes

55

General Mach Discussion / Re: z steper trouble

« on: December 18, 2012, 05:59:10 PM »

I did go to ports and pins and unchecked port 1. I measured pin 6 and ground to pin 25. I got a steady 0.5 MV

56

General Mach Discussion / Re: z steper trouble

« on: December 17, 2012, 01:02:21 AM »

Hood, I was a millwrite. I am not sure what you are talking about. What Port and where do I find it. Completely dumb on some of this stuff. But I am learning through the school of hard knocks as long as I can fine teachers

Also I did some more playing today. If I zero the DRO and move it in a direction, then move it in the same direction, it works fine. Change directions is when it separates its self and keeps running. Zero it out and it will work in that direction till I change again.

I haven't removed Norton basically because it's a comcast package> I will remove it in the near future when that computer becomes a designated computer. It almost is now.

57

General Mach Discussion / Re: z steper trouble

« on: December 16, 2012, 11:34:05 AM »

I don't have a scope. I don't know even if I could rent one.

58

General Mach Discussion / Re: z steper trouble

« on: December 16, 2012, 01:42:22 AM »

try this again

59

General Mach Discussion / Re: z steper trouble

« on: December 15, 2012, 05:24:16 PM »

XML  File

60

General Mach Discussion / Re: z steper trouble

« on: December 15, 2012, 11:33:18 AM »

I have Norton