Hello Guest it is March 29, 2024, 06:12:47 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - johnny

Pages: « 1 2 3 4 5 6 7 8 9 »
11
General Mach Discussion / Re: License change
« on: May 17, 2016, 03:26:51 PM »
I hope there is another way.  The power source isn't working and its now worth a new one.  I bought a new computer but it takes a few days for the parallel port t to get here and installed so I can hook it up to the machine

by the way, thanks for the help,  Its guys like you that's willing to help guys like me so we can look good

12
General Mach Discussion / License change
« on: May 17, 2016, 12:12:45 AM »
I  will be changing computers after the first of the month.  what is the procedure to change the license to the new computer.

thanks guys

13
General Mach Discussion / Re: parallel port
« on: April 07, 2016, 12:15:55 AM »
good talking to you Mr. hood.  Can I take the ribbon and back plate from tis one and work it in.

14
General Mach Discussion / Re: parallel port
« on: April 01, 2016, 02:27:02 AM »
thanks, ,I will check it out

15
General Mach Discussion / Re: parallel port
« on: March 31, 2016, 09:32:15 PM »
$200 plus a operating system ?

16
General Mach Discussion / parallel port
« on: March 31, 2016, 03:18:29 PM »
I need to replace my designated computer.  The new ones do not have a parallel port as you know.  I know I read some where about a external parallel port that worked well with CNC. ~ ~That's the end of my knowledge about it. Advice Please ~ ~ Also Is there a good minimum CPU size I should stay above,


17
General Mach Discussion / Re: Mill to lathe configuration
« on: February 11, 2016, 04:08:49 PM »
I found the answer  thank you

18
General Mach Discussion / Mill to lathe configuration
« on: February 10, 2016, 06:42:21 PM »

I have a Shopmaster Eldorado that is a Lathe, Mill combo.  I use it mostly for hobby work and also to help repair car wash problems

I want to run the lathe and I know I read some where  how to configure the  settings to run X/Y instead of X,Y and Z on the mill side but I haven't found it.  I have never tried any serious lathe work but want to play.

I want to configure the lathe to run CNC and learn a bit about threading.  Any help would be good

19
General Mach Discussion / Re: mach 3 troubles
« on: December 04, 2014, 03:02:45 PM »
I have disconnected all plugs and reconnected these. I did gain movement to the X Y Z axis but no spindle or speed control. I am attaching a wire dia. What wires control spendle movement and speed control? ?


20
predator is a edit software and I think the problem is me. I was as you guys say, "reading instructions" and I think it is a posting mistake. I hope.
Senior moment.

Pages: « 1 2 3 4 5 6 7 8 9 »