1
General Mach Discussion / Re: Inputs not working
« on: July 15, 2012, 12:57:22 PM »
You are correct. I guess I was expecting too much from the automatic setup of inputs. Once I enabled the input in the table it correctly detected the signal in the automatic setup of inputs.
And I guess the automatic setup of inputs looks at the specified port only. As you stated I had estop enabled but on port0. I switched it in the table to be port 1 and it also was detected in automatic setup of inputs.
In summary for automatic setup of inputs to work you need the input enabled and the port assigned correctly first.
Thanks for help and the simple fix.
Jim
And I guess the automatic setup of inputs looks at the specified port only. As you stated I had estop enabled but on port0. I switched it in the table to be port 1 and it also was detected in automatic setup of inputs.
In summary for automatic setup of inputs to work you need the input enabled and the port assigned correctly first.
Thanks for help and the simple fix.
Jim