41
General Mach Discussion / Whining stepper motors
« on: August 17, 2012, 12:14:24 AM »
They drag,whine, and have a mind of their own. Would this be a driver problem or a motor problem? Thanks.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
OK 2 ways to do it IF you want to run it from the keyboard Go to Config /Pinsports and enable the inputs for thcup and thcdown. Then click on Emulate and select a Hotkey for the event for each .
At that point restart mach3 and you should be able to raise and lower the Z running a program.
2nd option (best( is to setup to real intut switches and wire them into the port that way you can bring the switchs with you to the table for a closeup veiw and adjust it on the fly
OK DOES the machine have a TORCH Height Control (THC) installed ?
Or are you trying to control it manually ?
(;-) TP
OK look back at your message and see IF you gave us ANY clue as to what you have machine/thc wise (;-)
All I can see is that you have a plasma ?? MAYBE
(;-) TP