Messages

21

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 13, 2012, 07:48:04 PM »

I have redrawn this thing 5 times and it does the same thing. Where would I find Mach3 scaling? Thanks for looking @ it.

22

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 13, 2012, 05:26:37 PM »

It is a vent for a charcoal grill. Thanks

23

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 13, 2012, 05:04:17 PM »

Thanks

24

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 13, 2012, 04:37:06 PM »

I must be scaling it bringing it into sheetcam. Everything works, but it is 2 times the size I need. How do I use scale in S-cam???

25

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 10, 2012, 10:19:26 PM »

I.E. I am cutting a 3.5 inch disc with 4---- 3/4 inch holes. I am getting a 7 inch disc with 4------1 1/2 inch holes.

26

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 10, 2012, 10:16:25 PM »

LOL. Thought I had it......It is making all the cuts twice the size I drew them in Draftsight. I there a place in Mach3 to adjust sizes? Thanks Again. Tom

27

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 10, 2012, 01:56:50 AM »

GOT IT. THANKS for the help.

28

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 10, 2012, 12:47:00 AM »

In  sheet cam can you insert the kerfs like you do in autocad?

29

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 10, 2012, 12:34:09 AM »

I am new, so very sorry to be so dumb. I redrew it and opened in sheet cam , ran the post processor and get the same error as before, but last time it gave me 6 of the same error, now it is down to 1. but same error as before.

30

General Mach Discussion / Plasma -Easy question but got me stumped

« on: October 09, 2012, 06:40:43 PM »

Mach 3- Sheet cam - plasma.
<<Cut start is above rapid clearance plane.......... >>
What did I do wrong?? TYIA.