Messages

11

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 14, 2012, 02:15:07 AM »

Speaking of Z axis........It was slamming down to the plate, now it is stopping before it gets all the way down. Specs on the Z are :
Z axis is up/down and settings are lower.
1630
90
60
155411424
5
3
 I feel like I am getting close to getting a part cut. LOL.

12

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 14, 2012, 12:21:33 AM »

  How long did it take for you to get that sharp? worked like a champ.

13

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 13, 2012, 11:44:44 PM »

X -Y-A-
Steps per - 1630
Velocity - 499.98
ACC - 50
Gs - .12950952
Step pulse - 5
Dir pulse - 3

Z axis is up/down and settings are lower.
1630
90
60
155411424
5
3

14

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 13, 2012, 10:17:30 PM »

Motor tuning and set up?

15

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 13, 2012, 10:00:34 PM »

Axis tuning section??   where would I find that?   I just put a new driver on it but have double checked and the dip switches are set where they are supposed to be.  But yes I have a good idea you are correct, now to figure out how to find the axis tuning.   lol.

16

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 13, 2012, 09:30:11 PM »

All you have to do is command a move from the MDI say G1 X5.000. The machine should move  X 5.000 +/- inches.

(;-) TP

cool thanks for the hint

17

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 13, 2012, 09:29:15 PM »

Drew a 5 inch line and it went exactly 10 inches........

18

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 13, 2012, 09:16:56 PM »

let me draw up a 5 inch line and go check. thanks.

19

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 13, 2012, 08:55:44 PM »

?

20

General Mach Discussion / Re: Plasma -Easy question but got me stumped

« on: October 13, 2012, 08:54:27 PM »

Trying to figure how how to post the G-code now.