11
General Mach Discussion / Re: JNC-40M configuration?
« on: June 21, 2012, 06:43:51 PM »
Thanks for the reply, Mike.
If you want the English screen back, you can go to View > Load Screens, browse to the Mach3 folder, and select 1024.set.
Instead of re-creating the mill configuration, you could also have made a copy of Mach3Mill.xml, this is the Mill config file.
What numbers did you end up with for the Motor Tuning and Setup?
Thanks!
If you want the English screen back, you can go to View > Load Screens, browse to the Mach3 folder, and select 1024.set.
Instead of re-creating the mill configuration, you could also have made a copy of Mach3Mill.xml, this is the Mill config file.
What numbers did you end up with for the Motor Tuning and Setup?
Thanks!