Messages

71

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 26, 2012, 11:40:18 AM »

I think I may have found something it's not the same machine but they use the same control.

http://www.shadowcnc.com/shadowmanual.htm

72

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 26, 2012, 03:15:02 AM »

So do I need a bandit controller manual?

73

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 26, 2012, 02:53:12 AM »

I don't have a manual I'd really like to have one. I can get more info when I get into work tomorrow.

74

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 26, 2012, 02:30:25 AM »

Thanks for the heads up and fast response u just saved me $400

75

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 26, 2012, 02:22:49 AM »

I didn't know I could I guess I will cancel the snap amp

76

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 26, 2012, 01:35:35 AM »

So I bought the KFlop Kanalog and Snap Amp but it only puts out 80V and my motors r 90V. Tom said it will still work but my max rpm will be lower.

77

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 25, 2012, 11:26:05 AM »

I'm ready to star tearing into it but I don't really know where to start should I gut it all but the spindle motor wires and servo motor wires?

78

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 24, 2012, 09:46:52 PM »

I see there is a whole section about running mach on vista and 7 so nvm on that question. Here are the pics and one of the top of my tool changer/drawbar. It looks like I won't be able to run an encoder on top of that as it probably isn't always engaged.

79

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 24, 2012, 06:15:11 PM »

Right on. I'll get a pic up ASAP. Hey I was wondering can I get Mach3 to run on windows 7? I want to have it on my computer with bobcad. Or is it a bad idea? Would a dedicated comp be better?

80

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 24, 2012, 03:17:51 AM »

So how would I tell if I had a encoder?