Messages

61

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 28, 2012, 03:42:00 PM »

So which encoders should I pick up? I was doing some reading and it looks like I want Rotary Encoders but I haven't a clue which ones to buy.

62

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 28, 2012, 03:18:57 PM »

63

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 28, 2012, 01:54:24 PM »

J6 has a set of wires that goes to J1 and the wires that come in from the resolver on J6 are for x y and z. I will have some more pics up soon

64

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 28, 2012, 01:44:06 PM »

 

65

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 28, 2012, 12:30:22 PM »

So I just traced the wire back to the bandit control it has 7 wires total per resolver and it goes into a circuit board labeled J6

66

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 27, 2012, 09:19:10 PM »

Well that is the quill servo for my Z and that should be a piece of cake cuz it protudes a bit at the past the pulley. The X and Y have me worried. So maybe for those I could run a 1:1 ratio pulley off of the ball screws to a encoder? Or would that be inaccurate? I'll trace the resolver wire tomorrow morning

67

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 27, 2012, 02:38:52 PM »

got the cover off with some wiggling

68

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 27, 2012, 12:15:15 PM »

I took the 4 screws off the top of the motor and it didn't come off. I don't know where to go from there. Should I remove the other 4 that the cables hook into?



Now that you mention it I did see this when I was taking those pics yesterday.

69

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 26, 2012, 08:37:50 PM »

So I'm guessing the Amps are in the first photo but I'm not sure.

70

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: May 26, 2012, 02:26:24 PM »

I'll take pics of all 3 panels and u would probably be able to tell me where the amps r located