Messages

11

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: June 28, 2012, 06:50:46 AM »

So are my - & + 10V signal wires are controlled through a total of 2 wires per axis?

12

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: June 28, 2012, 06:26:47 AM »

Cool I understand more than I did b4. So now I'll hook up my signal wires and order my encoders today.

13

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: June 27, 2012, 08:47:47 PM »

Oh good. Can u help me understand this a little better. I don't really know what goes to what. I realize where the encoders go other than that I am not sure where anything else goes. Is it possible to wire in my tool changer also? I am having trouble understanding JP6 and JP11.

http://dynomotion.com/Help/SchematicsKanalog/ConnectorsKanalog.htm

14

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: June 27, 2012, 11:32:14 AM »

Yea I was able to hook it up one way and get CW rotation the reverse the polarities and get CCW on all 3.

Now I'm sort of stumped. I have 8 shielded wires going into the old control consisting of many more smaller wires inside there. I'm slowly labeling them all and removing them. I need to figure out what wires are going where and then maybe I'll understand it better. 

15

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: June 26, 2012, 06:22:59 PM »

I wired it up differently and I have multi directional control from one side to the other now plus it will stop when i turn the knob to the middle with a little creep. Is this correct and I had it wired up wrong before?

16

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: June 25, 2012, 06:34:07 PM »

So I did what you said on the X axis. It worked like you explained there was some creep. It was almost stopped minor creep then medium pace and full on rapid. Now what? Should I test the rest of them in both directions?

17

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: June 24, 2012, 01:54:03 PM »

none of the motors are connected to the ball screws but I will keep that in mind. So should I have purchased 2 9V batteries and connectors and hook one up the correct way and one up backwards?

18

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: June 24, 2012, 01:52:57 PM »

so I have 3 prongs on the pot which is which? is the wiper the middle one?

19

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: June 24, 2012, 01:43:15 PM »

Which pot should I use?

20

General Mach Discussion / Re: Kasuga NC mill to CNC ?'s

« on: June 24, 2012, 01:34:30 PM »

Now how would I hook up the pot and 9V?