Messages

1

General Mach Discussion / Re: How to get rid of pauses between different segments of a program

« on: October 04, 2020, 11:24:25 PM »

Here is the zip file...

2

General Mach Discussion / Re: How to get rid of pauses between different segments of a program

« on: October 03, 2020, 02:18:33 PM »

As per request I have zipped the programs I want to run seamlessly instead of pausing between each section...

3

General Mach Discussion / Re: Two issues to fix

« on: May 06, 2012, 10:44:54 PM »

I am relatively new to this and I bought meshcam to render drawings to 3D and I guess I was fixated on using Vectric.  I will try more of Meshcam's features.  Thanks for the
heads up...BC

4

General Mach Discussion / Re: Two issues to fix

« on: May 06, 2012, 09:44:42 PM »

I wonder if the process i used to get the drawing into 3d had an effect -  used Meshcam to make an .stl file which i opened in cut 3D....

5

General Mach Discussion / Re: Two issues to fix

« on: May 06, 2012, 09:29:59 PM »

Yes, I'll need to get to my garage to get a copy...metal bldg no internet without a lot of hassle...I'll get back to you...BC

6

General Mach Discussion / Two issues to fix

« on: May 06, 2012, 08:51:43 PM »

1.  Router stays running regardless of "M"commands.  Where is the switch that I need to turn on/off so I can get the router to respond.  (Bosch router running off of single AC relay.)  All the axes work properly.

2,  "R,i,j,k words all missing for arcline 6295"  What does that mean?  I created the program with Vectric Cut 3D

Thanks in advance for any guidance you can send my way.......