11
PoKeys / Mach 3 setup with Pulse engine
« on: April 24, 2012, 03:01:56 AM »
Guys, help.... i must be missing something easy but i can not get it to work.
- pokeys hooked up to drivers and new firmware, connection lan network
- mach 3 latest plugin and pulse engine set up properly including activation code
- motors run using the pokeys software directly.....but not in mach 3 ...?
Mach 3 setup of motor to Port 10 pin 38 and 46.
It seems that mach 3 does not recognizes the port 10, but this was the way the usb version was recognised.
jogging is not possible.
What am i missing?
Seldom
- pokeys hooked up to drivers and new firmware, connection lan network
- mach 3 latest plugin and pulse engine set up properly including activation code
- motors run using the pokeys software directly.....but not in mach 3 ...?
Mach 3 setup of motor to Port 10 pin 38 and 46.
It seems that mach 3 does not recognizes the port 10, but this was the way the usb version was recognised.
jogging is not possible.
What am i missing?
Seldom