1
General Mach Discussion / Mach 3 wants to start much lower than ZERO, tool offset IS turned off
« on: October 28, 2012, 07:33:03 PM »
Hey guys,
Can someone please enlighten me on what I might be doing wrong. I'm using mach 3 with Vectric aspire. It's been a couple months since my last cut and suddenly it has a mind of it's own. I touch off the surface of the material with Z and Zero it out. I'm not using any tool offsets and I did verify that it is turned off. When I start the run, Z is plunges down MUCH further than it should be. It should be going down to my Safe Z (0.2) and going on into the program from there.
Anyone got any ideas?
Thanks.
Can someone please enlighten me on what I might be doing wrong. I'm using mach 3 with Vectric aspire. It's been a couple months since my last cut and suddenly it has a mind of it's own. I touch off the surface of the material with Z and Zero it out. I'm not using any tool offsets and I did verify that it is turned off. When I start the run, Z is plunges down MUCH further than it should be. It should be going down to my Safe Z (0.2) and going on into the program from there.
Anyone got any ideas?
Thanks.