Hello Guest it is April 04, 2020, 08:17:21 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Leadhead

Pages: 1 2
1
General Mach Discussion / Re: USB Camera connection
« on: August 22, 2018, 12:44:34 PM »
Klaus -  SUCCESS
Computer did not have SP3 loaded, put it in, then changed the USB port and everything worked.
My thanks for your kind assistance.

Rod

2
General Mach Discussion / Re: USB Camera connection
« on: August 22, 2018, 09:49:43 AM »
Klaus - Reloaded your V3.09 onto the XP computer. It responded with the following:-
Camera plugin needs SP3 (OK)
ENVIRONMENT VARIABLE PATH NOT FOUND.(OK)
The ordinal 254 could not be located in the dynamic link library msi.dll.

Rod

3
General Mach Discussion / Re: USB Camera connection
« on: August 22, 2018, 03:50:28 AM »
Klaus - Followed your kind advice. But no solutions. On the XP machine I am getting "Video OCX (driver) cannot be connected" report.

4
General Mach Discussion / Re: USB Camera connection
« on: August 21, 2018, 06:54:55 AM »
Klaus - Yes both camera`s are USB. Both work normally on this PC and with Planet CNC.

5
General Mach Discussion / Re: USB Camera connection
« on: August 21, 2018, 01:47:54 AM »
Klaus - Thanks for reply. I have tried both V2 and V3 on a Win 10 PC. I put the cameras on another Mach 3 setup (Win XP ) and got the same report with both cameras. No other programmes on this PC. The report is the same with the Mach 3 camera screen?

6
General Mach Discussion / USB Camera connection
« on: August 20, 2018, 12:09:54 PM »
Hi - I have a problem getting a USB camera to be recognised by Mach 3.  I am getting the report "unable to load OSG driver"  The camera works perfectly in Planet CNC.
If there is a solution I would be most grateful to know please?

7
Is the offer available for the UK?

8
General Mach Discussion / Re: Lathe Spindle Synchronisation
« on: June 24, 2018, 05:14:12 AM »
Thank for the information gentlemen. Pondering my options as to whether it is worth doing. -  I have a manual lathe standing next to the CNC lathe

9
General Mach Discussion / Re: Lathe Spindle Synchronisation
« on: June 24, 2018, 01:05:25 AM »
I suppose my question is more. Can an induction motorised spindle be synchronised?

10
General Mach Discussion / Lathe Spindle Synchronisation
« on: June 23, 2018, 01:25:10 PM »
I have had to replace the servo motor on my small CNC lathe with a 1.5hp 3 phase induction motor driven from single phase through a VFD.
My question is, would it be possible to synchronise the spindle for screwcutting. -  If so can I use the simple "hall effect switch" and magnet on the spindle method.
Your advice appreciated.

Pages: 1 2