11
General Mach Discussion / Re: Changes X0 in middle of file, licensed ver 2.52
« on: October 07, 2007, 10:58:55 AM »
It is just the x axis that seems to shift and it happens while the file is cutting. Another interesting thing is that I can start the machine and run Mach's steps per unit utility prior to cutting the file and at 12000 spi a 4" X moves goes 4". After the problem occurs I can rerun the utility and a 4" move goes approximately 2.5 inches. The DROs notice no change when the problem occurs and act as though X0 has not shifted. Art has been helping as well but I most certainly appreciate your input.