1
General Mach Discussion / Re: Mach3Turn Offsets?
« on: February 23, 2013, 03:34:12 PM »
This is exactly what I use and your right, it is a nice function for repeatablity.
On another note, Does anyone know where to find the mach3 G76 codes. I used the threading wizard and it posts out the long hand. I would like to know what the different letters on the line apply to so I can manully edit them. I know most of them, but there are I few I do not recoqnize. Any table in mach3 to explain them?. In the meantime I will chech my Fanuc manual.
Marty
On another note, Does anyone know where to find the mach3 G76 codes. I used the threading wizard and it posts out the long hand. I would like to know what the different letters on the line apply to so I can manully edit them. I know most of them, but there are I few I do not recoqnize. Any table in mach3 to explain them?. In the meantime I will chech my Fanuc manual.
Marty