Hello Guest it is March 28, 2024, 10:16:32 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Patriot Fan

Pages: 1
1
Newfangled Solutions Mach3 Wizards / Re: NFS Turn Wizard
« on: June 07, 2012, 12:40:47 PM »
Hi Ron,
  I've been having a problem with OD thread in NSFturn. My machine works great with all of the other funtions, but when I load a thread from the thread library the X axis moves in from home and when the program gets to the G76 line the Z axis stays still and the program just sits. I've made sure that the feed is in inches per revolution. I've uninstalled NSFturn and downloaded it again to see if I had a bug in downloading. As I said turn, face ,OD taper and drill work fine. I've added some specialty threads to the thread library, that I use and they re-act in the same manner. This wizard is a great tool and saves me alot of time.
Thanks,
Mark

2
Newfangled Solutions Mach3 Wizards / Re: NFS Turn Wizard
« on: April 27, 2012, 04:24:36 PM »
Ron,
 I went back to the auto configure and then turned my computor off. When I opened the program everything was there. You were right about the screen. Thank you, now I can enjoy this great new wizard. I really appriciate all of your help, now I can go make some chips!
 Thanks,
 Mark

PS: I plan to make some videos of my machine in action and will post on You-Tube.

3
Newfangled Solutions Mach3 Wizards / Re: NFS Turn Wizard
« on: April 27, 2012, 01:03:46 PM »
Ron,
  I checked my screen and it is 1024x768. I tried the auto adjust and that didn't work and then tried to manual adjust and it wont bring up the bottom of the screen. I can see a bar at the bottom of the screen, but other than that it looks just like your video.
 Thanks ,
 Mark

4
Newfangled Solutions Mach3 Wizards / Re: NFS Turn Wizard
« on: April 26, 2012, 09:47:55 PM »
Ron, I will check the res. on my screen, right now I'm sending
this from my phone. However the " DO-IT & POST" buttons  are not
in the Bitmaps file. I don't know if that helps.
Thanks, Mark

5
Newfangled Solutions Mach3 Wizards / Re: NFS Turn Wizard
« on: April 26, 2012, 05:01:16 PM »
It's an Acer AL1916W 19" monitor. Thank youn for the quick reply.
 Mark

6
Newfangled Solutions Mach3 Wizards / Re: NFS Turn Wizard
« on: April 26, 2012, 04:12:42 PM »
I have watched the video on you-tube and downloaded TurnWiz.  I have the license for Mach3 and Wiz lic. I think it's a great and useful
tool to add. However when I down loaded and added to the turn addons file I'm not getting the "DO_IT and POST" buttons when I try to create a program. I've checked the Bitmaps file and they are not there. Please help with this, It would be greatly appriciated.
 Thank you,
  Mark

7
General Mach Discussion / Re: Reset Button Flashing
« on: April 12, 2012, 09:01:28 AM »
Thank you it worked for me as well. This is a very helpful forum.

Pages: 1