Hello Guest it is April 18, 2024, 02:15:22 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - zappafan1

Pages: 1
1
General Mach Discussion / Re: Mach3 homing direction
« on: March 20, 2012, 08:46:19 AM »
Hood:  I meant the internal "pendant" in mach3 accessed by the "Tab" key.  In any case, I finally got my settings correct, and now things are working as they should.

2
General Mach Discussion / Mach3 homing direction
« on: March 12, 2012, 05:18:14 PM »
Hello, all: I'll make this as short as possible. I go to reference my 3 axis, and the Z and Y move as they should, but I have to set the "reversed" option in Homing/Limits to make the X go in the correct direction. However, if I use the Mach3 Jog pendant, the Y goes in the opposite direction (tries to home towards Y +)  I've tried changing the Active Low in Ports and Pins/Motor Outputs, then changed it back, and I've also tried switching two wires to my 4-wire steppers, all with no solution.  Any ideas?  Why would I get opposite directions using the Jog?

Pages: 1