Messages

21

Third party software and hardware support forums. / centriod cnc4 with stepper motors can i use anything from this and add mach3

« on: February 22, 2012, 09:19:58 PM »

hi, i have a centriod cnc4 with stepper motors it is from 1992 belive it or not it ran fine up to last mounth the pc that came with it is dead . the software that runs the cnc4 unit is rs232 and faunuc code . so the problem is it will not run with windows . so what i'm looking for is help running this with mach3 and keep my stepper motors . any help would be great . thanks

22

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: February 22, 2012, 08:53:04 PM »

hi i'm scott i am a shop foreman in a fab shop also lead machinist . been in the feild for 30+ years . we do alot of manual maching still in are shop . we also have an old centriod cnc4 that is slowly dieing . so that is what brings me to this forum .