Hello Guest it is March 28, 2024, 06:52:06 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dschwei

Pages: 1
1
General Mach Discussion / Distance above material for rapid
« on: November 15, 2013, 07:43:36 AM »
Hello all,  I have a question.........  When I cut straight through 4 x 8 plywood material, sometime the sheet is slightly bowed.  This doesn't really effect my parts in use but sometimes as the the router moves between cuts on the same sheet,  it crosses a high spot and scuffs a very shallow path to the next actual plunge.  How do I raise, or control the distance above the material as it moves betwen cuts?

Pages: 1