Messages

11

General Mach Discussion / Re: y axis changing direction while running g code

« on: June 16, 2012, 03:01:36 PM »

im using the mill one, both dir and pulse are on 5--- im thinking my controller may be at fault i sent them a message hopefully they will return with some info
i had a router setup on my screen but it doesnt show in xml for some reason

12

General Mach Discussion / Re: y axis changing direction while running g code

« on: June 16, 2012, 01:37:28 PM »

ok here it is
Thanks in advance
Doug

13

General Mach Discussion / Re: y axis changing direction while running g code

« on: June 16, 2012, 01:08:40 PM »

ok im lost how do i send it ?

14

General Mach Discussion / Re: y axis changing direction while running g code

« on: June 16, 2012, 01:00:48 PM »

ok i can do that

15

General Mach Discussion / y axis changing direction while running g code

« on: June 16, 2012, 12:01:20 PM »

need a lil help, when running a program and it calls for x32.000 y5.350 the y axis will go there but then it will wander to the other side of the peice. I tried using the manual control and y axis will run positive when the positive button is pushed but when negative is pushed it will still run positive but hitt negative twice and the motor will change to run negative im running mach3 and have 24 volt power a tb6560 controller and 266 sanyo denki steppers ive changed the y stepper thinking it was the motor but still the same problem ive checked all my wiring but every thing is good there, ive even tried slowing the motor down or speeding up but nothing helps
I sure hope one of you can help with some info
Thanks in advance
Doug

16

FAQs / open gl codes

« on: February 08, 2012, 03:18:37 PM »

im so new the paint hasnt wore off my pc    seriously though when i try to upload a file from lazycam to mach3 i get an open gl code error message i dont know where to look for an answer so maybe one or more of you have run into this before? i would appreciate any info you might have

thanks in advance
Doug