Hello Guest it is April 23, 2024, 09:31:53 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - vbmw002

Pages: 1
1
General Mach Discussion / Logical configuration problems
« on: February 06, 2012, 03:05:24 AM »
What are the conditions and differences of the mach3 often speed movement and precise to stop the use of two motor pattern?

2
General Mach Discussion / Re: Motion abnormalities
« on: February 06, 2012, 02:57:43 AM »
Quote from: Hood on February 06, 2012, 02:47:16 AM
Not a clue what you are asking I am afraid, you will need to try and explain what your problem is.
Hood

MACH3 which set the maximum speed of the servo motor is 3000mm/min the acceleration 1500mm/ss finish roughing code, finishing code motor frustrated phenomenon, the movement is not smooth.

3
General Mach Discussion / Re: Motion abnormalities
« on: February 06, 2012, 02:56:51 AM »
MACH3 which set the maximum speed of the servo motor is 3000mm/min the acceleration 1500mm/ss finish roughing code, finishing code motor frustrated phenomenon, the movement is not smooth.

4
General Mach Discussion / Motion abnormalities
« on: February 05, 2012, 10:28:33 PM »
In the use mach3 control 4 axis engraving and milling machine, Yaskawa servo motor sports, motor frustrated phenomenon is what causes?

Pages: 1