1
General Mach Discussion / Machine movement
« on: May 25, 2013, 03:40:44 PM »
Need help. I have been using my Mach 3 cutting plasma and doing fine.
My problem is I just switched to the router and my mill screen is not moving the gantry.
I looked at the config screen, ports and pins and set up the mill screen the same as the plasma and still no go.
Any suggestions?
My problem is I just switched to the router and my mill screen is not moving the gantry.
I looked at the config screen, ports and pins and set up the mill screen the same as the plasma and still no go.
Any suggestions?