1
General Mach Discussion / C6 and C10 boards Isolation?
« on: August 27, 2017, 11:41:40 AM »
HI there I am trying to connect a D700 Vfd to a C6 and C10 which are both in the same box with separate 5V and 12V but wired to the same input pwr socket. The C10 is only to control a couple of inputs and to drive the spindle board. I am getting start and speed control seemingly correctly but stop only slows the spindle so perhaps there is some interaction between the two supplies.
Does this seem likely and would splitting the input power to a wall wart type on one perhaps help. Also would anybody here have a wiring guide as I have tried to modify a previous connection with a different spindle board.
I would like to make sure this isn't the problem before going back to the local supplier of the inverter who has helped before but has no idea of the Mach 3 side of the setup.
Thanks Bob.
Does this seem likely and would splitting the input power to a wall wart type on one perhaps help. Also would anybody here have a wiring guide as I have tried to modify a previous connection with a different spindle board.
I would like to make sure this isn't the problem before going back to the local supplier of the inverter who has helped before but has no idea of the Mach 3 side of the setup.
Thanks Bob.