Hello Guest it is September 27, 2020, 01:07:08 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - crozjota

Pages: « 1 2 3
General Mach Discussion / Graphics screen
« on: April 16, 2012, 01:09:47 PM »
Hi All,
Been running Mach 3 on my (almost fully) converted Denford Orac lathe for a couple of months now and no real problems except I do not have the component on the graphics display, the tool path is there but no component graphic, it was there when I first ran it and now its disappeared! what have I done wrong, and can I get it back? lol
Wayne (making blanking plugs for brake master cylinders right now!!)

FAQs / Re: touchscreen for mach
« on: April 05, 2012, 03:37:44 PM »
I just bought a new, boxed 16" Advantech screen of evilbay. Touch screen on Mach 3? essential! works a treat.

Pages: « 1 2 3