1
General Mach Discussion / Re: calibration still off? Parts not right size.
« on: December 18, 2011, 07:16:22 PM »
When I calibrate in the settings tab I let mach move the axis say 1" then it sets the calibrated value. Then I
re-zero my machine reset my dial indicator and then verify the setting by moving
the x axis in the MDI box X1.0 and see what the dial indicator reads.
My screws are precision acme rods from McMasterCar.
re-zero my machine reset my dial indicator and then verify the setting by moving
the x axis in the MDI box X1.0 and see what the dial indicator reads.
My screws are precision acme rods from McMasterCar.