71
General Mach Discussion / Re: Troubles with PWM output Voltage
« on: December 22, 2013, 08:35:36 PM »
The gecko converts an at pin 14 incoming PWM signal to 0 to10 Volts analogue output to control the VFD
no, it needs the PWM on pin 14
so far as I understand the manual the gecko needs a source voltage from the VFD for the 0 to 10V output
pin 7 VFD Ground
pin 9 VFD +10VDC
pin 8 0 to10V to VFD input
Quote
Does the gecko need 0-10v initially coming in
no, it needs the PWM on pin 14
so far as I understand the manual the gecko needs a source voltage from the VFD for the 0 to 10V output
pin 7 VFD Ground
pin 9 VFD +10VDC
pin 8 0 to10V to VFD input