31
General Mach Discussion / Re: Wizards OD arc help
« on: January 22, 2014, 10:31:11 AM »
There is no option to reverse the cutting direction as I see.
Alex
Alex
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
(so A axis tuning is working ok and spindle tuning steps per unit acts funny). When running at higher steps/s, the servo amp will smooth the rotation. With that slow movement, it really jumps, stays, jumps, stays..It acts not funny, it acts how you set it up. 1RPM = 20 pulses per minute thats 1 puls every 3 seconds. The A axis acts the same, try