191
General Mach Discussion / Re: Circles are not round
« on: October 10, 2012, 04:49:51 AM »
Hi,
your g code looks ok. But the circle is to small and the feedrate to high to test things out.
if you have used a small long endmill it may have bend.
I am shure your problem is a not good tuned servo system / settings or the kinematics
Alex
your g code looks ok. But the circle is to small and the feedrate to high to test things out.
if you have used a small long endmill it may have bend.
I am shure your problem is a not good tuned servo system / settings or the kinematics
Alex