11
Show"N"Tell ( Your Machines) / CNC machine i been working on...........
« on: February 28, 2012, 09:29:02 PM »
I been about couple of months that i have been working on this machine. The plans are taken form the buildyourcnc.com book design free pdf. The linear system that the machine used is the aluminum angle w/t ball bearing and the linear driver is a 4' all threaded lead screw. The wood that i have used is MDF. Basically i follow the entire book from step to step expect some stuff. I was only allowed to put only 4 pic,
i didn't had any good wood cutting system so the pieces cut were not very persice which led to machine being not so great, but still very pleased "The problem that i facing right now is if i tighten the screws too much the gantry gets stiff but hard to move. If i loosen them then the gantry get wobbly thus still pretty precise cuts but no big stuff".
i didn't had any good wood cutting system so the pieces cut were not very persice which led to machine being not so great, but still very pleased "The problem that i facing right now is if i tighten the screws too much the gantry gets stiff but hard to move. If i loosen them then the gantry get wobbly thus still pretty precise cuts but no big stuff".