Hello Guest it is March 28, 2024, 05:32:44 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - John05

Pages: 1
1
Hello, I am new to CNC and have my machine set up and I did cut a few sample projects but those were given to me ,ready to cut.
I downloaded a small program called "DeskEngrave" which is used to convert text to g-code or a dxf file. The problem is that I don't know what settings to put in.  Here is what is listed, ORIGIN X             WIDTH                 ANGLE
                                                                           
                                                                          ORIGIN Y             HEIGHT                RADIUS

  If someone can show me how the settings should be to cut one letter then I would have a better understanding of it. Any help would be most appreciated.

Thank You
John

2
General Mach Discussion / Motors not responding
« on: November 20, 2011, 12:13:16 AM »
Hello, I am having a problem with my 3 axis cnc machine. The hard drive died in my PC that was controlling the CNC machine.I installed the Mach3 demo in my new PC and after many tries at adjusting the settings,  I cannot get the motors to move. I can hear them activate when I turn on the controller but that's all. I would appreciate any assistance on solving this problem.

Thank You
John

Pages: 1