Hello Guest it is September 19, 2020, 03:48:28 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Claus

Pages: « 1 2
11
Thanks Trickey

I hope some of the tough guys in here can help me with my issues.

Thanks

Claus

12
General Mach Discussion / Re: Motors not working
« on: November 11, 2011, 04:39:02 PM »
Hello Hood

I have cheked the wiring 4 times now and it should be ok.
power input on the board is meassured to 24V
i have also cheked and meassured the printer cable and and it was also fine 1:1

Thanks
Claus

13
General Mach Discussion / Motors not working
« on: November 11, 2011, 03:08:04 PM »
Hello Gentlemen

I have a new home build 3 axis CNC router, i have now tried for countless hours to get the stepper motors to work but no luck.
all 3 stepper motors are completely dead.

PC is powerfull enough.
Latest version of Mach3
i have followed the set up accordingly ( both Software and hardware)

I have no e-stop or stop switches connected at all ( could it be that ?)

Motor is  is NEma 23 stepper and breakout board is  TB6560

When i turn on the PC ,3 small red led lights turns on on the board, when i start Mach 3 they go out.
Arrow keys works on the screen but no movement on axes
[/img]


Hope you guys can help me
Thanks
Claus

14
Hello

I am Claus from Denmark
Part time Luthier

One of my good friends have helped me building a fine CNC Mill   80 x 80 x 35 cm work space
Mainly for making parts for my guitars.
I am completely new into 3D and CNC but aim to be a
good user.

Cheers

Claus

Pages: « 1 2