Hello Guest it is November 20, 2019, 05:28:45 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - b504now

Pages: 1
1
Mach3 under Vista / Parallel port missing
« on: June 13, 2013, 09:54:58 AM »
I had to migrate to a new PC recently, and I have been stumped by the parallel card. I have a windows 7, 32 bit computer with a parallel port attached to the PCI-E bus. And for the life if me I cant get the Mach3 to interact with the parallel port.

A poster on the buildyourCNC forum suggested that MACH3 cannot see the parallel port on a PCI-E bus. Is that true ?

Thanks

2
General Mach Discussion / Re: Input to Mach3 from breakout board
« on: November 15, 2011, 04:10:03 PM »
Thanks. That is exactly what I needed.

I've got it. I would not have looked at that so I appreciate the guidance

3
General Mach Discussion / Input to Mach3 from breakout board
« on: November 15, 2011, 08:37:43 AM »
I am looking to tie the speed of my CNC router to an input from the breakout board. I have two input pins open and I want to tie them to the buttons that increase or decrease speed. I was hoping there was a map somewhere in this but I can't seem to find it.

I need some guidance. Not looking for someone to do my "homework" but I'm hoping that someone can point me at a few sections so I can get started.

Thanks

Pages: 1