Messages

61

Newfangled Solutions Mach3 Wizards / Re: Coil winding machine ( Wizard needed)

« on: September 26, 2006, 04:15:47 AM »

Hi,

Thank you. I have found out the issue. I did not press the ENTER before.

Zoltan

62

Newfangled Solutions Mach3 Wizards / Re: Coil winding machine ( Wizard needed)

« on: September 25, 2006, 08:55:16 AM »

Hi,

Can somebody help me? It is very frustrating. I do not know how to use the screen. I can open it, see it, but I can not setup it and I can not generate the code and of course no movement. Please, help. I would like to see it working even if it is not doing right things but at least working as in the video.

Thank you.

Zoltan

63

Newfangled Solutions Mach3 Wizards / Re: Coil winding machine ( Wizard needed)

« on: September 21, 2006, 02:28:53 AM »

Hi,

Thank you again. Now I can see it (the screen) but I do not know how it works. If I modify something in wizard area when I go to the next window it reset to previous value. I could not generate any code and it seems that I can not setup it and it does not control. Could someone help me again with few guidelines? I adapted my first hobby cnc machine to winding coils machine and I would like try to make some coils.

Thank you.

Zoltan

64

Newfangled Solutions Mach3 Wizards / Re: Coil winding machine ( Wizard needed)

« on: September 21, 2006, 12:52:58 AM »

Aha....OK. I did not put the folder in bitmap folder, only the set file in Mach3 dir. THANK YOU.

Zoltan

65

Newfangled Solutions Mach3 Wizards / Re: Coil winding machine ( Wizard needed)

« on: September 20, 2006, 12:30:51 PM »

HI,

Please, help. Mine does not work. I mean it is a black screen with few lines, few windows with some values there but nothing else from the picture attached in the archive. Now, all other screens I downloaded and talked about in my previous reply are working, just I have some issues which are probably related with resolution that the size is smaller than the display window. What I done was I just extracted the set file to Mach3 dir and then opened with Load screen command. Could, you, please, advice what I can do?

Thank you.

Zoltan

66

Newfangled Solutions Mach3 Wizards / Re: Coil winding machine ( Wizard needed)

« on: September 20, 2006, 05:30:06 AM »

Hi,

It seems that it does not work for me. I have tried also silverblue screen and pink screen. The silverblue does not work either, but pink screen does work. What do you think I did wrong something?

Thank you.

Zoltan

67

Newfangled Solutions Mach3 Wizards / Re: Coil winding machine ( Wizard needed)

« on: September 19, 2006, 02:56:32 AM »

Hi,

Sorry for dumb question but where is the program which is running the winding machine from video clip? I mean the final version of this program.

Thank you,

Zoltan

68

General Mach Discussion / Re: Initial feed rate

« on: August 28, 2006, 05:20:54 PM »

Hi Brian,

Could you, please, help me to undesratnd where I find "init String" and "Configuration Settings page"?

I want to change the initial Feed rate.

Thank you,

Zoltan