Messages

11

General Mach Discussion / Re: skipping steps

« on: May 20, 2007, 05:05:09 PM »

I have run already as I made the optimization, all steps have been done. You can see on the screen that I have nothing installed on the computer besides Mach3 and Quantum, and the instalattion is a standard one.

Zoltan

12

General Mach Discussion / Re: skipping steps

« on: May 20, 2007, 04:31:58 PM »

512 M. Is there a problem?

Zoltan

13

General Mach Discussion / Re: skipping steps

« on: May 20, 2007, 04:13:27 PM »

Any comments regarding these screens? I do not know if they look ok or is there something wrong which can give the skipping steps.

Thank you for help.

Zoltan

14

General Mach Discussion / Re: skipping steps

« on: May 18, 2007, 10:46:16 AM »

OK. I did again the driver test. I captured twice the screen. Please, find it attached.

Thanks,

Zoltan

15

General Mach Discussion / Re: skipping steps

« on: May 18, 2007, 01:21:28 AM »

OK. Sorry. I did not know. Still, learning and experimenting.

Zoltan

16

General Mach Discussion / Re: skipping steps

« on: May 17, 2007, 02:07:13 PM »

Hi Brian,

I captured three screens. The first is when I first run the driver test. The other two were captured when I run the driver test second time.

Zoltan

17

General Mach Discussion / Re: skipping steps

« on: May 17, 2007, 11:09:35 AM »

I do not know how to get it?? I run the driver test and it seems very, very stable and smooth. The spikes are very small. How I can capture in a screen to post here?

Zoltan

18

General Mach Discussion / Re: skipping steps

« on: May 17, 2007, 06:38:23 AM »

NO. I am planning to mount a Joystick. Jus bought one.

Zoltan

19

General Mach Discussion / Re: skipping steps

« on: May 17, 2007, 06:32:11 AM »

It is 5, both.

Zoltan

20

General Mach Discussion / Re: skipping steps

« on: May 17, 2007, 06:16:17 AM »

Hi Brian,

I am running in mm mode, and I have 100 steps/mm, as on one rotation the screw is making 20 mm and I am running 200 steps/rev motors by 10 microsteppings Geko drivers.

Thank you,

Zoltan