101
General Mach Discussion / Motor Tuning - Maxed out velocity at 84ipm at 45k Hz.
« on: June 08, 2014, 03:55:06 PM »
I just made some new brass gibs for my X2 and for the first time ever attempted to go higher rate than I've been on table movement in the past.
I was surprised to see the flag come up that say's velocity requested exceeds blah blah blah limits of configuration.
I know they're are others that are moving at a faster rate than this at 45k Hz and I understand that leadscrew tpi has a lot to do with that.
But does it understand my max feedrate is based upon "steps per" or something?
Where's the bottleneck if it's not in the leadscrew?
Am I missing another setting somewhere?
Don't get me wrong, I'm very happy with the new feedrates, just taken aback that the system is infringing on faster movement.
I was surprised to see the flag come up that say's velocity requested exceeds blah blah blah limits of configuration.
I know they're are others that are moving at a faster rate than this at 45k Hz and I understand that leadscrew tpi has a lot to do with that.
But does it understand my max feedrate is based upon "steps per" or something?
Where's the bottleneck if it's not in the leadscrew?
Am I missing another setting somewhere?
Don't get me wrong, I'm very happy with the new feedrates, just taken aback that the system is infringing on faster movement.