1
General Mach Discussion / Re: screwed up sign
« on: October 27, 2011, 09:10:35 AM »
Hi gumball
though new to this forum, I've suffered chronic CNC for some years
FWIW, I've just imported your DXF into VCP (4.6) and it ran flawlessly, both as a Vcarve and relief, no open vectors
if you're interested, give me a shout and I'll send you the gcode (not yet up to speed on posting files in this forum)
Regards, Lin
though new to this forum, I've suffered chronic CNC for some years
FWIW, I've just imported your DXF into VCP (4.6) and it ran flawlessly, both as a Vcarve and relief, no open vectors
if you're interested, give me a shout and I'll send you the gcode (not yet up to speed on posting files in this forum)
Regards, Lin