Hello Guest it is September 21, 2023, 05:57:59 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rauno

Pages: « 1 2
11
Hello everyone!

I am a dental CNC technician from Estonia. I have been working in dental industry over a year now.
I mostly work with an Imes-Icore 750i and 3Shape Dental software.

In the future, hopefully in near future, I plan on building a few CNC machines myself.


Rauno

12
General Mach Discussion / Mach3 and Precimill M4
« on: October 18, 2011, 01:42:08 AM »
Hi everyone!


I am looking for new control software for an old machine. It is an old dental mill from DCS, the Precimill M4. The manufacturer has closed business and the software is most likely from the last century.

It is basically 3-axis machine with material flipper, automatic tool change and Alfred J├Ąger spindle (KS3-18-60).

I have been looking towards Mach3 for some time now, even tried to configure it a few times, but had no luck on my own.

So I decided to register and post a topic on this forum to get some help with it.

I attached some schematics about the machine. Take a look and give me your opinion if this software is the right one for me.
If someone can give me some help configuring the soft, it would be great.


Thanks for your attention.

Regards,
Rauno

Pages: « 1 2