1
General Mach Discussion / Re: Mach3 and Precimill M4
« on: November 19, 2012, 06:14:01 AM »
I would have to talk to my boss, but if the price is right, everything is possible...
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
If the GCODE is written in roman number, you know it is old![]()
![]()
![]()
Quick look and it would seem your machine uses DC servos and analogue amplifiers (drives) so its not just a case of hooking up Mach. Easiest and cheapest rout would likely be to get new drives that accept Step/Dir input. Which drives would be suitable will depend on the current and voltage of these motors.
Hood