1
General Mach Discussion / Re: Tool hight measuring after tool change - macro ?
« on: January 30, 2012, 01:59:12 AM »
Hi there. Nice explanation, thats much clearer. Thanks.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Did you try the motors with the BOB removed?
If the max voltage you get is 3.3Volts then you may have a problem with that BoB.I'm taking that to mean the BOB is not compatible with the computer? Because this was all working 12 months ago.