11
General Mach Discussion / Parallel port help
« on: February 19, 2012, 11:27:12 AM »
Hi,
After finally getting my machine to work well, I was having problems with my old 2nd hand PC, which kept crashing. So I installed Mach3 on a newer machine. The problem is the irregular pulsing from the parallel port.
When I run the driver test, although there are long periods of "excellent", there are also irregular messages about pulsing "too fast" and "too slow"
I have not tried it connected to my machine, but I don't imagine it will prove very successful. The port is set to run under ecp and epp mode.
Can anybody suggest a solution please?
Thanks,
Gareth
After finally getting my machine to work well, I was having problems with my old 2nd hand PC, which kept crashing. So I installed Mach3 on a newer machine. The problem is the irregular pulsing from the parallel port.
When I run the driver test, although there are long periods of "excellent", there are also irregular messages about pulsing "too fast" and "too slow"
I have not tried it connected to my machine, but I don't imagine it will prove very successful. The port is set to run under ecp and epp mode.
Can anybody suggest a solution please?
Thanks,
Gareth